Loopback-Configured loopback mode for the PIC received from the DCE: CTS (Clear To Send: up or down), DCD (Data Carrier Detect: up or down), DSR (Data Set Ready: up or down), or TM (Test Mode: up or down).Ĭlocking mode-Clocking used for the transmitĭCE and is looped back as the transmit clock. PIC sent to the DCE: DTR (Data Terminal Ready: up or down) or RTS (Request To Send: up or down.) Is receiving the receive clock signal) or Not detected (receive clockĮquipment) or DTE (data terminal equipment) Sync loss count-Number of times the synchronization Resync history-Information about resynchronization Transmitted packets-Number of transmittedĭropped packets-Number of packets dropped Total number of egress queues in use on the specifiedĬoS queue number and its associated user-configured forwardingĬlass name. Total number of egress queues supported on the specified (perhaps once every 10 seconds), the cable, the far-end system,Įrrors-Sum of the outgoing frame terminated If the number of carrier transitions increments quickly Is unplugged, the far-end system is powered down and up, or another This numberĭoes not normally increment quickly, increasing only when the cable Usually, this field reports protocols that the
#Get loopback serial number code#
The incoming packet match code discarded because they were not recognized Giants-Number of frames received that are This number increments once for every packet that is dropped by theįraming errors-Number of packets received The following paragraphs explain the counters whose meaning mightĮrrors-Sum of the incoming frame terminated Output packets-Number of packets transmitted Received and transmitted on the physical interface. The format is Last flapped: year-month-day hour: minute: second timezone ( hour: minute: second ago). Success-CHAP authentication was successful. (Most likely with RADIUS authentication.)Ĭlosed-CHAP authentication is incomplete. Time since the last keepalive packet was sent.Ĭonf-ack-received-Acknowledgement was received.Ĭhallenge Handshake Authentication Protocol (CHAP) during its transaction.Ĭhap-Chal-received-Challenge was receivedįor the challenge sent, but CHAP has not yet moved into the Success Seen hh: mm: ss ago)-Number of keepalive packets sent by PPP and the Received by PPP and the time since the last keepalive packet was received. Input: number (last seen hh:mm:ss ago)-Number of keepalive packets Of keepalive packets sent by PPP and the time since the last keepalive Of keepalive packets received by PPP and the time since the last keepalive
Of keepalive packets a destination must fail to receive before the Of keepalive packets a destination must receive to change a link's Values are described in the “Link Flags” section under Common Output Fields Description.īetween successive keepalive requests.
Possible values are described in the “Interface Flags” Section under Common Output Fields Description. Possible values are described in the “Device Flags”
Which reflects its initialization sequence.ĭevice. Values are described in the “Enabled Field” section under Common Output Fields Description. Table 1: show interfaces (Serial) Output Fields
0 kommentar(er)
